Enhanced Stereo; Front Panel Display Setup - NAD T 777 Owner's Manual

ENHANCED STEREO

Please refer to the same description of 'ENHANCED STEREO' under the
'LISTENING MODES' segment of the 'OPERATION - USING THE T 777 - MAIN
MENU' .

FRONT PANEL DISPLAY SETUP

The Vacuum Fluorescent Display (VFD) and On-Screen Display (OSD) can be
shown in various ways by navigating through the parameters at the 'Display
Setup' menu.
NOTE
The configurations set forth at 'Display Setup' are carried over whenever
it is enabled during A/V Preset setting. Please see also the section below
about 'AV Presets. '
Display : Select 'On' to display all applicable data or characters at the VFD.
Nothing will be shown at VFD if 'Temp' is selected. At 'Temp' setting however,
whenever any of the front panel controls or their corresponding keys in the
remote control is activated, the appropriate VFD characters will be shown
temporarily and then fade away. Note that if any of the Zones are at powered
state, they will be continually shown at VFD even at 'Temp' setting.
Dimmer : If it is desired to reduce the brightness of the VFD, set Dimmer to
'Dim' . Otherwise, select 'Bright' to return to normal VFD brightness.
USING THE T 777 – SETUP MENU
Line 1, Line 2 : The VFD shows two main lines of data or characters. Line
2 is the line of data or characters located at the lower bottom of the VFD
while directly above it is Line 1. For both lines, one can select which display
could be shown by choosing through the following
Main Source : Shows the active Source.
Volume : Current Volume level is shown.
Listening Mode : Selected Listening Mode is shown.
Audio Source Format : Shows the active Source' s detected audio format.
Audio Codec: Displays the detected audio stream format like Analog,
PCM Surround, Dolby TrueHD, DTS-HD Master Audio and other formats.
Video Mode: Show the video resolution of the active input source.
Details shown include the video resolution with frame rate. For a better
understanding of these video details, consult with your NAD Audio
Specialist or your distributor's technical department.
Zone 2-Zone 3-Zone 4 Source : The assigned Source for the
applicable Zone is shown.
Off : Select 'Off' if it is desired not to show any data at the applicable Line.
Temp Line : Choose between Line 1 and Line 2 as the desired line where
VFD will be temporarily shown if 'Temp' is selected at 'Display' option as
described above.
OPERATION
23