Craftsman 917.25148 Owner's Manual page 8

,,, = ........................................
ASSEMBLY
CONNECT BATTERY (See Fig. 2)
_ CAUTION: Do not short battery termi-
nals. Before connecting battery, re-
move metal bracelets, wristwatch
bands, rings, etc,
Positive terminal must be connected
first to prevent sparking from acciden-
tal grounding,
o Lift hood to raised position.
• Open terminal access doors, remove terminal protec-
tive caps and discard.
• If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 ampso
= First connect RED battery cable to positive (+) battery
terminal with hex bolt, flat washe r, lock washer and hex
nut as shown Tighten securely,
o Connect BLACK grounding cable to negative (-) battery
terminal with remaining hex bott, flat washer, lock
washer and hex nut, Tighten securely_
o Close terminat access doors
Use terminal access doors for:
o Inspection for secure connections (to tighten hard-
ware),
o Inspection for corrosion
• Testing battery,
o Jumping (if required),
. Periodic charging.
LOCK FLAT
HEX NUT WASHER WASHER
DISCARD TERMINAL X . . / HE×
TERMINA_ .....i ;
AccEss _ i i i_t;_
DOOR _ _.i:, -i _
(BED)
j* BLACK)
CABLE
INSTALL SEAT
(See Fig. 3)
Adjust seat before tightening adjustment knob
o Remove cardboard packing on seat pan
• Place seat on seat pan and assemble shoulder bolt.
• Assemble adjustment knob and flat washer loosely.
Do not tighten.
o Tighten shoulder bolt securely
o Lower seat into operating position and sit on seat.
o Slide seat until a comfortable position is reached which
allows you to press clutch/brake pedal all the way
down°
o Get off seat without moving its adjusted position.
. Raise seat and tighten adjustment knob securely.
SEAT PAN
SHOULDER _'X
ADJUSTMENT
KNOB
SEAT
X
FIG. 3
FIG, 2