Advertisement
Fujitsu Confidential
1.0 The Basics
Note: The term "the home screen" used in this manual refers to the character display which appears
immediately after powering on the phone.
1.1 Switching On/Off
Press and hold the POWER/END key for one second to switch the phone on or off.
1.2 Making a Call
Enter the area code + number then press the SEND key. Check with your operator to see if
you must enter the area code. If you make a mistake dialing, press CLR to erase digits one
by one. Press and hold CLR to clear the entire display. Once the SEND key has been
pressed, "Dialing..." will be displayed on line one of the display and the number being
called will be on line two. Once a connection has been made the call timer will be displayed
and continue to increment as seconds pass.
1.3 Ending a Call
Press END
1.4 Answering a Call
Press any key to answer the call.
When there is an incoming call, the phone rings and flashes "Call" on line one of the
display and the caller id on line two.
1.5 Auto-answering
In addition to Press Any Key Answering, the phone will automatically answer an incoming
call after four rings. The number of rings before answering can be modified by pressing
MENU, then using the Down Arrow key to highlight the SETUP menu selection, pressing
OK, then highlighting Auto Answer, pressing OK, then entering the desired number of
rings, then pressing OK. Entering "0" for the number of rings will disable Auto-answering.
1.6 Last Number Redial
Press SEND, SEND
The first send will display the recent dialed list and the second will dial the last number
called.
1.7 Speed Dial
Press the number location (1-99) in the directory, then press SEND. If the location is empty
a message will be displayed to that effect.
1.8 "9" Key Emergency Dialing
Press the 9 key and hold it for 3 seconds. The phone will dial 911.
Note: Does NOT work if Keypad is locked.
Fujitsu Confidential
Page 4
C:\Ready_To_Convert\Doc\71213.DOC
05/16/01
Advertisement
