ALDI Q1W-SP20-1900A User Manual page 26

GB IRE
Troubleshooting
Fault
2.2 kW high pressure
washer is working, but
keeps cutting out
No pressure or only slight
pressure is built up
Large fluctuations in
pressure
2.2 kW high pressure
washer has a leak
26 26
www.coreservice.co.uk
Cause
Mains cord damaged
Internal electrical
connection separated
ON/OFF switch defective
Air in the system
The air must be bled from
the device
No supply of water or
insufficient supply of
water
Dirt filter plugged
Spray lance set to low
pressure
2.2 kW high pressure
washer draws in air
High-pressure nozzle
plugged
Insufficient water
pressure
Supply hose is kinked
Hose connections loose
Leak in the pump or
internal connections
Solution
− Consult the customer
service team
− Operate the 2.2
kW high pressure
washer without the
high pressure hose
connected until the
water is dispensed
without bubbles. Then
put the high pressure
hose back on.
− Check/open the feed
valve
− Check the supply hose
for leaks or blockage
− Check and clean the
filter
− Check the setting of
the spray lance
− Check the supply hose
for leaks
− Clean the high-
pressure nozzle
− Check the water
pressure
− Check the supply hose
− Turn the water inlet
adapter and screw
connection of the
high-pressure hose
hand-tight
− Consult the customer
service team
AFTER SALES SUPPORT
01904727501
GB IRE
019022605