Verifying The Acl Logging Configuration - Cisco Nexus 3600 NX-OS Security Configuration Manual

Verifying the ACL Logging Configuration

Before You Begin
Ensure that the ACL you want to apply exists and that it is configured to filter traffic in the manner that you
need for this application.
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Verifying the ACL Logging Configuration
To display ACL logging configuration information, perform one of the following tasks:
Command
switch# show hardware access-list tcam region
switch# show ip access-lists
switch# show ipv6 access-lists
Cisco Nexus 3600 NX-OS Security Configuration Guide, Release 7.x
88
Command or Action
switch# configure terminal
Enter one of the following commands:
• switch(config)# interface ethernet slot/port[.
number]
• switch(config)# interface port-channel
channel-number[. number]
• switch(config)# interface mgmt port
Enter one of the following commands:
• switch(config-if)# ip access-group access-list
{in}
• switch(config-if)# ipv6 traffic-filter
access-list {in}
switch(config-if)# show running-config aclmgr
switch(config-if)# copy running-config
startup-config
Purpose
Enters global configuration mode.
Enters configuration mode for the
interface type that you specified.
Applies an IPv4 or IPv6 ACL to the layer
3 interface for traffic in the ingress
direction.
(Optional)
Displays the ACL configuration.
(Optional)
Copies the running configuration to the
startup configuration.
Purpose
Displays the TCAM sizes that will be applicable on
the next reload of the device.
Displays the IPv4 ACL configuration.
Displays the IPv6 ACL configuration.
Configuring IP ACLs