Scientific Atlanta DPX2213 User Manual page 34

How Do I Install the Modem for Telephone Service?
3 Connect the active RF coaxial cable to the CABLE connector on the back of the
cable modem. The cable modem begins an automatic search to locate and sign on
to the network that provides the telephone service. This process may take up to 5
minutes. The modem will be ready for use when the ONLINE LED status
indicator on the front panel stops blinking and illuminates continuously
Note: Use an optional cable signal splitter to add a TV, a DHCT or set-top
converter, or a VCR.
4 Test your telephone service by lifting the receiver of each attached telephone to
verify that the dial tone can be heard and that you can make and receive
telephone calls. This process may take several minutes.
Notes:
The TEL 1 and TEL 2 LED status indicators on the front panel of the cable
modem illuminate when telephony service is enabled.
The TEL 1 or the TEL 2 LED status indicators on the front panel of the cable
modem blink when the attached device is "off the hook."
34 734348 Rev C