Connecting The 8300Hd To An External Sata Hard Disk Drive (Optional) - Scientific Atlanta EXPLORER Explorer 8300HD Connecting Manual

Connecting the 8300HD to an External SATA
Hard Disk Drive (optional)
Complete the following steps to install a SATA drive.
1. Make sure that both the 8300HD and the external SATA drive are unplugged from power.
2. Connect the data cable for the SATA drive to the 8300HD.
3. Plug in power to the external SATA drive.
4. Plug in the 8300HD power cord, and then turn on the 8300HD.
5. Follow the on-screen instructions. One of the following occurs:
• If it is a new drive or one used on another device, you will be asked to format it.
• If the drive is formatted and will work with this 8300HD, you will get a confirmation that the
drive is working.
Explorer 8300HD DVR
THIS DEVICE IS INTENDED TO BE ATTACHED
TO A RECEIVER THAT IS NOT USED TO
RECEIVE OVER-THE-AIR BROADCAST
SIGNALS. CONNECTION OF THIS DEVICE
CABLE
IN ANY OTHER FASHION MAY CAUSE
IN
HARMFUL INTERFERENCE TO RADIO
COMMUNICATIONS AND IS IN VIOLATION
OF THE FCC RULES, PART 15.
CATV CONVERTER
MADE IN MEXICO
Cable Input
External SATA
Hard Disk Drive
WARNING:
Electric shock hazard! Unplug
all electronic devices before
connecting or disconnecting any
device cables to the 8300HD.
Guidelines for Using the External SATA Hard Disk Drive
The external SATA hard disk drive requires continuous power. If the SATA drive loses power while
the 8300HD is plugged in, the 8300HD may stop current recordings or not provide enough space
for future recordings. Follow these guidelines for using the SATA drive:
• Do not plug in the power cord for the SATA drive to a switched outlet or to the AC outlet on the
8300HD.
• Do not turn off, disconnect, or unplug the SATA drive while the 8300HD is plugged in.
Recommendations for the SATA Drive
Contact your cable service provider for a list of approved external SATA hard disk drives. At a
minimum, your SATA drive should have these capabilities:
• External SATA Connector - SATA II: Cable and Connector, Revision 1.0 (www.sata-io.org for more
information)
• Drive Speed: 7200 RPM (5400 RPM without Multi-room); 133 MB/sec
• Capacity: Only one SATA drive can be connected to the 8300HD. The 8300HD will not support
a separate port multiplier.
• SATA Drive Power: The SATA drive should power on when plugged in and should not be
controlled by a switch.
16
CABLE
OUT
OUT 1 OUT 2
Pr
A
U
D IR
L
Pb
I OPTICAL
AUDIO
O
OUT
R
S - VIDEO
VIDEO DIGITAL VIDEO
OUT
Y/V AUDIO OUT
SATA
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS:
RISQUE DE CHOC
ELECTRIQUE NE PAS OUVRIR
1394 1394
SATA
120 VAC 120 VAC
60HZ 5A 60HZ 80W
LISTED 14H1
CABLE EQUIP.
To
Unswitched
Wall Outlet
To Unswitched
Wall Outlet
T11209