Sony CMT-HX7BT Operating Instructions Manual page 22

Pairing this system with Bluetooth
headphones
Pairing is an operation where Bluetooth
devices register with each other
beforehand. Use the procedure below
to pair the system with your Bluetooth
headphones. Once a pairing operation
is performed, it does not need to be
performed again. If pairing is already
completed, proceed to "Playing music on
this system" (page 23).
1
Select a function other than the
Bluetooth function.
Press FUNCTION
2
Place the Bluetooth
headphones to be connected
to this system within 1 meter of
the system.
3
Put the Bluetooth headphones
in pairing mode.
For details about the operations of the
Bluetooth headphones, refer to the
operation manual supplied with your
Bluetooth headphones.
4
Press and hold BLUETOOTH

OPR on the unit for about 7
seconds until the BLUETOOTH

indicator fl ashes.
Sound output from the speakers is
stopped.
5
Enter the passcode.
Follow the same procedure as in
step 4 of "Pairing this system with a
Bluetooth device" (page 19).
Once pairing is completed and the
connection is established, the system
display changes as follows:
"Connect"  Name of the Bluetooth
device
GB
22
CMT-HX7BT.GB.3-095-517-11(1)
To cancel passcode entry partway
Press 
Notes
 "Passcode" may be called "Passkey, " "PIN
code, " "PIN number" or "Password, " etc.
depending on the device.
 Th is system only supports numerical
passcodes up to 4 digits.
 Th e pairing standby status of the system is
cancelled aft er about 30 seconds. If pairing is
not successful, redo the procedure from step
1.
 While connected to a Bluetooth device, this
system cannot be detected and a connection
cannot be established from another

repeatedly.
Bluetooth device.
To erase all the pairing registration
information
Press BLUETOOTH 
1
unit.
When the system is connected with a
Bluetooth device (when the Bluetooth
device name or other information
appears in the system display), press
and hold BLUETOOTH OPR
the unit for about 2 seconds to put the
system in Bluetooth standby mode.
2
Press CLEAR
"Delete?" appears.
3
Press ENTER
"Complete!" appears and all the
pairing information is erased.
Note
To connect with Bluetooth headphones aft er
performing this operation, you must enter the
passcode again.

.

on the

on

.

.
Playin
You ca
Blueto
system
AVRC
1
Se
Blu
Pre
2
Es
Blu
Pre

un
lig
If m
tha
is p
sys
to
(C
to
rec
att
est
On
the
"C
dev
3
Sta
th
De
hea
sys
etc
Fo
Blu
op
Blu
4
Ad
Pre
VO
CMT-