Carrier 30HW-900-008 Installation Instructions

SAFETY CONSIDERATIONS
Installation of this accessory can be hazardous due to sys-
tem pressures, electrical components and equipment location.
Only trained, qualified installers and service mechanics should
install and service this equipment.
When installing this accessory, observe precautions in the
literature, labels attached to the equipment, and other safety
precautions that apply.
• Follow all safety codes.
• Wear safety glasses and work gloves.
• Use care in handling and installing this accessory.
USAGE
PART NO.
19XR04026501
30HW-900---008 19XR04026502
19XR04026503
30MP-900---021 30MPA,MPW016-071, 30MPE
INTRODUCTION
Install this package after bringing unit into the building. For
30MPA, MPE, MPW units, and 19XR pumpout unit, the unit
must be raised off from the shipping skid by approximately 6
inches. After the accessory mobility package is installed, the
unit can be moved to its final location.
PACKAGE CONTENTS
PART NO. QUANTITY
4
30HW-900---008
4
2
4
24
30MP-900---021
24
24
48
Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.
Catalog No.04-53300194-01

Installation Instructions

Part No. 30HW-900---008, 30MP-900---021
UNIT
ITEM
Wheel assemblies (includes
wheel, nut, and washer)
Spacers
Wheel Assemblies with Locks
Wheel Assemblies without Locks
5
/ -in.-18 x 1.0 in. Bolts
16
5 / -in.-18 Nuts
16
5 / -in. Lock Washers
16
5
/ -in. Flat Washers
16
Printed in U.S.A.
Mobility Package Accessory
30MP Chillers
1. Examine the package contents. The 30MP units require 6
wheels. Check to be sure there are 6 wheel assemblies in
the carton. Each wheel requires 4 bolts, 8 flat washers, 4
lock washers, and 4 nuts. Notify your Carrier representa-
tive if pieces are missing or if the accessory is damaged.
2. Jack up the unit to a height of approximately 6 in. above
the floor and block it in place. Be sure to block the unit
securely so that it cannot fall during installation of the
mobility package.
3. Mount the wheel assemblies to the unit. Mount one wheel
assembly with lock to the baseframe mounting points 3
and 4 as shown in Fig. 1 and 2. Mount one wheel assem-
bly without lock to the baseframe mounting points 1, 2, 5
and 6 as shown in Fig. 1 and 2.
4. Tighten each nut so that it holds the wheel assembly se-
curely once the assembly is mounted on the unit. A mini-
mum torque of 12 ft-lb (16 Nm) is recommended.
5. Remove the blocks, and carefully place unit back onto the
floor. The unit is now ready to roll to the desired location.
25.15
(639)
NOTE: Dimensions in ( ) are in mm.
Fig. 1 — Baseframe Mounting Points, 30MPA,
MPE, and MPW Units
Form 30-36SI Pg 1
30MPA, MPE, MPW
INSTALLATION
+ +
1 2
TOP VIEW
+
+
50.30
(1278)
6
5
4
3
+ +
CONTROL BOX
27.00
(686)
10-18
19XR
Replaces: New