Connecting
5.1
Chapter overview
This chapter describes how to wire the sensors for operation with a wall mounted transmitter.
1. Sensor wiring (Page 48)
2. Connecting sensors to transmitter (Page 61)
5.2
Basic safety instructions
5.2.1
Unsuitable cables, cable glands and/or plugs
Unsuitable cables, cable glands and/or plugs
Risk of explosion in hazardous areas. May cause death or serious injury.
• Use only cable glands/plugs that comply with the requirements for the relevant type of
• Tighten the cable glands in accordance with the torques specified in Finalizing cable
• Close unused cable inlets for the electrical connections.
• When replacing cable glands use only cable glands of the same type.
• After installation check that the cables are seated firmly.
FSS200 clamp-on sensors
Installation Manual, 08/2017, A5E36255466-AC
WARNING
protection.
wiring (Page 60).
5
43