If you have other SCSI adapters installed, you must make sure SSD7110 only support UEFI boot . the SSD7110 controller UEFI will be loaded firstly. If not, try to move it to another PCI slot. Otherwise you may be unable to boot up your system.
Page 3
Disable "Secure Boot", set "Attempt Secure Boot" to "Disabled". Step 3 Flash UEFI Rom to SSD7110 Unzip SSD7110 UEFI package to root dir(/) of a USB flash driver,and insert the USB flash drive to the motherboard; b. Booting from the UEFI USB flash and enter the UEFI environment ;...
SSD7110 Controller Windows Installation Guide Step 4 Create Array a. Attach three NVMe SSD to SSD7110 Controller ; Note Make sure your USB flash partition format is NTFS or FAT32. b. Boot, in the presence of the motherboard Log screen, there will be NVMe SSD information:...
Page 5
SSD7110 Controller Windows Installation Guide e. Command ”Arraycreate.efi” to enter the Utility: f. Command ”create RAID0 ”. Create RAID0 array with all disks and with maximum capacity. g. Command “exit”; h. For more command usages, refer to Appendix A. Step 5 Install Windows a.
Page 6
SSD7110 Controller Windows Installation Guide c. Enter Boot list, select start from UEFI DVD: d. Install Windows, to “Where do you want to install Windows?”, you can see three Legacy disk: e. Click “Loader driver”,in the pup-up window, click “Cancel”:...
Page 7
SSD7110 Controller Windows Installation Guide f. Uncheck "Hide drivers that aren't compatible with this computer's hardware": g. Then plug the USB flash with the driver file onto the USB interface of the motherboard, click “Browse”, select the driver file:...
Page 8
SSD7110 Controller Windows Installation Guide h. After load the driver, back to “Where do you want to install Windows?” interface, the three Legacy disk have become RAID partitions. For windows server, it will prompt “Windows Can’t be installed on this driver.”,you should click this point and click OK.
SSD7110 Controller Windows Installation Guide Delete Command Syntax delete {array ID} Examples <<< delete 1 Delete the first array from Logical device list. <<< delete 2 Delete the second array from Logical device list. Info Command Syntax info Display physical device list and logical list ...