Advertisement
G
Control Module
Blue Shrink
1
Determine the best location for the Control
Module. If installed by a professional, the
customer should be consulted. An optimal
location is easily visible and accessible from
the driver's position, and does not interfere
with normal driving. Avoid locations that
require reaching through or around the
steering wheel.
2
Clean the mounting surface thoroughly.
3
Mount the Control using the pre-applied
adhesive.
4
Route the cable to the Interface and plug
into the connector labeled "Control Module. "
5
Secure and conceal the cable under trim
panels.
H
Concealed Alert
Indicator
Gray Shrink
1
Determine the best location for the Alert
Indicator. If installed by a professional, the
customer should be consulted. An optimal
location is clearly visible from the driver's
position and does not take a driver's eyes off
the road for more than a moment.
2
Ensure there are no hidden cables, brackets,
or other components behind the mounting
location, and that there is adequate clearance
behind the panel.
3
Cover the mounting surface with masking
tape to prevent accidental scratches.
4
Carefully mark the location and drill a 1/4"
hole through the mounting panel.
5
Remove the masking tape protecting the
trim panel.
6
From the front side, snap one of the panel
bezels provided into the hole.
7
Snap the Alert Indicator into the panel bezel
from the back side.
8
Route the cable to the Interface and plug
into the connector labeled "Concealed Alert
LED. "
9
Secure and conceal the cable under trim
panels.
I
Rear Radar Receiver
1
Follow the same installation instructions as
for the Front Radar Receiver but with the
receiver's arrow oriented to point out the rear
of the vehicle.
2
Entry points to the vehicle's interior may be
available behind the license plate or lights.
J
Rear Laser ShifterMax
Sensors
optional
IMPORTANT! When using optional Rear
ShifterMax sensors ensure DIP switches 3
and 4 are moved down to the REAR
SHIFTER position. See the Interface
illustration on pg 9.
1
Follow the same installation instructions as
for the Front Laser ShifterMax Sensors but with
the sensors oriented to point out the rear of
the vehicle.
2
Entry points to the vehicle's interior may be
available behind the license plate or lights.
Radio Mute Cable
1
The radio mute cable (included) allows the
detector to be connected to compatible audio
systems with a "Radio Mute" wire or connector.
Once connected, the audio level of the stereo
is reduced automatically during an alert.
2
Please refer to your audio system's manual
for proper connection to your audio system.
12
13
Operation Test
optional
After all components are installed correctly:
1
Turn ESCORT iX Ci on by turning on the
vehicle's ignition and, if necessary, press the
power button on the Control Module.
2
ESCORT iX Ci will cycle through a startup
sequence.
3
If any error messages come up, see the
Owner's Manual troubleshooting section for
suggested solutions.
USB Update Cable
The USB Update cable allows updating the
ESCORT iX Ci's DEFENDER database and
firmware. ESCORT iX Ci's red light and speed
camera DEFENDER database is easily updated
using our exclusive detector software tools
found on our web site. Firmware, or the
operating software for the detector, can also
be updated using these tools.
In order to have access to these updates,
please register your ESCORT iX Ci at www.
EscortRadar.com. Once registered, you will
receive email notifications when updates are
available.
If you have any questions, please call or visit
our website. One of trained radar specialists
will be happy to assist you.
800-543-1608 / EscortRadar.com
Advertisement
