2-36
Features and Controls
The following describes how the URPA display lights appear as the vehicle
gets closer to a detected object:
Description
amber light
amber/amber lights
amber/amber/red lights
amber/amber/red lights flashing
The system can be disabled
through the Driver Information
Center (DIC). See "Park Assist"
under DIC Operation and Displays
(With DIC Buttons) on page 3-45
or DIC Operation and Displays
(Without DIC Buttons) on page 3-50
for more information.
When the System Does Not
Seem to Work Properly
If the URPA system does not
activate due to a temporary
condition, the message PARK
English
Metric
8 ft
40 in
23 in
1 ft
ASSIST OFF displays on the DIC
and a red light will be shown on the
rear URPA display when the shift
lever is moved into R (Reverse).
This may occur under the following
conditions:
•
The driver disables the system.
•
The ultrasonic sensors are
not clean. Keep the vehicle's rear
bumper free of mud, dirt, snow,
ice and slush. For cleaning
instructions, see Washing Your
Vehicle on page 5-87.
•
A trailer was attached to the
vehicle, or a bicycle or an
object was hanging out of the
liftgate during the last drive cycle,
the red light may illuminate in
2.5 m
the rear display. Once the
1.0 m
attached object is removed,
URPA will return to normal
0.6 m
operation.
0.3 m
•
A tow bar is attached to the
vehicle.
•
The vehicle's bumper is
damaged. Take the vehicle to
your dealer/retailer to repair
the system.
•
Other conditions may affect
system performance, such
as vibrations from a jackhammer
or the compression of air
brakes on a very large truck.
If the system is still disabled, after
driving forward at least 15 mph
(25 km/h), take the vehicle to your
dealer/retailer.