Accessories Installation; Interface - SATO S8412 Operator's Manual

ACCESSORIES INSTALLATION

This unit provides installation instructions of the purchase options available for this printer. These instructions only
cover physical hardware installation. Refer to the Printer Configuration unit of this manual to configure the printer
for their use.
INTERFACE INSTALLATION
The diagram below displays the physical installation of interface hardware. Refer to the Configuration unit of this
manual for instructions on printer setup for the interface type chosen.
1. Switch off the printer (1, Figure 3-18) and and follow applicable lockout-tagout procedures.
2. Remove interface slot covering (not shown) from printer (1) as applicable.
3. Insert chosen interface board (2) into its assigned slot and secure using two screws (3).
NOTE: The interface slot identified EXT is assigned for peripheral device connection.
The center slot is asigned for standard interface card connection. And the remaining
slot is for use with PCI interface cards.
4. Repeat steps 2 and 3 for additional interface cards as applicable.
NOTE: Dependent on individual setup and operational requirements, multiple
interface cards may be required.
5. Connect interface cable (not shown).
NOTE: The interface cable to be used is dependent upon the type of card and the
device to be connected. Refer to this printer's operator manual for specific printer
connection instructions. Refer to peripheral device's documentation for its connector
identification.
S8400 Series Operator Manual
Unit 3: Installation
Figure 3-18, Interface Installation
3-25
1
3
2
PN: 9001160B