Connections - Sanyo SRT-4040 Instruction Manual

NB4QR/NA (SRT-4040 GB) Tue. Sept., 10/2002

CONNECTIONS

Connect the video camera and TV monitor as shown in the figure below.
NOTE:
Before making the connections, make sure the devices are disconnected from the power outlet.
Video camera
(sold separately)
SRT-4040 only
AC IN
PUSH
OPEN
Power cord
To outlet
Power Cord Installation (SRT-4040 only)
1
Plug the supplied power cord firmly into the AC
power input AC IN ~ socket.
2
Insert the plug of this power cord into a outlet.
NOTES:
œ For more details, please refer to the manuals
accompanying all other devices. If the connections
are not made properly, it may cause a fire or damage
the equipment.
œ You can use a VA-RMN01 Remote Control Unit (sold
separately) to control the VCR remotely.
œ If there is no video signal when the power is turned
on, "NO VIDEO" will be displayed on-screen.
English
From an external
audio source
SRT-4040DC only
OPEN COLLECTOR
1=500mA(Max.)
2= 50mA(Max.)
3=SEE MANUAL CONTROL IN 3
ALARM(1 SHOT)IN
DC 12-24V IN
PUSH
OPEN
REMOTE
DC power cord
(not supplied)
To remote control
(sold separately)
To DC power supply
NOTE (SRT-4040 only):
œ The grounded power cord (3-pin plug) must be
connected to a grounded power outlet.
NOTES (SRT-4040DC only):
œ Use a DC power cord rated A.W.G 18 (1.25 mm
more.
œ The table below indicates the DC power source output
and DC power maximum cord lengths.
DC power source output
18 V or more 2 A
12 ~ 16 V
9
TV Monitor (sold separately)
To
VIDEO
IN
jack
EXT TIMER
WARNING OUT 1 TAPE END OUT 2 SW OUT
(ALARM RESET) IN
SERIES IN 3 COM CONTROL OUT 3 TIMER OUT 3
AUDIO VIDEO
IN
IN
OUT
OUT
Coaxial
cable
(sold
To
separately)
VIDEO
OUT
jack
DC power maximum
cord lengths
3 A
2
) or
6 m
6 m