Fitting Procedure - Panasonic TY-VK55LV1 Fitting Instructions Manual

Fitting procedure

1. Removing the shipping lock
brackets
① Remove the two screws fastening each
of the six shipping lock brackets, then
remove the shipping lock brackets.
② Remove the side shipping lock screws
(one on each side).
③ Remove the protective cardboard.
* The unit mount plate may pop out if the
unit is lifted without removing the protective
cardboard.
Be sure to reattach the shipping lock
brackets, screws and protective cardboard
when shipping in the future.
Store the shipping lock brackets, screws
and protective cardboard in a safe place.
2. Mounting the mount bracket on the
main unit
① Use the mount bracket screws Ⓐ to fasten
the mount bracket Ⓕ to the main unit.
(Tightening torque: 1.8 to 2.2 N·m)
* The illustration of the main unit may differ,
depending on the model. The diagram at the
right is one example of a compatible model.
3. Mounting the surface alignment magnets onto the main unit
① Fasten the surface alignment magnets Ⓖ to the main unit using the magnet fi xing
screws Ⓑ.
* The forms of the surface alignment magnets Ⓖ differ according to the place where the main
unit is to be installed. Carefully check the place of installation and the forms of the surface
alignment magnets Ⓖ [(a) to (d)] before mounting.
Ⓖ Surface alignment magnets-(c)
Ⓖ Surface alignment
magnets-(d)
Mount bracket
Ⓕ
Main unit rear
: Magnets present
: No magnets (holder)
Side shipping
lock screw
Protective
cardboard
Unit mount
plate
Ⓐ
Mount with the
hooks facing
downwards.
Ⓖ Surface alignment magnets-(a)
Ⓖ Surface alignment
magnets-(b)
Mount
bracket
screws
27