Installing the Dispensing Tap
The design of the Dispensing Tap will
vary depending on the model
purchased.
The tap must be posi oned on the
benchtop with the outlet over a sink.
All Dispensing Taps are mounted
through a Ø35mm hole drilled in the
benchtop.
Before drilling the moun ng hole
ensure that there is sufficient
clearance beneath the bench to fix the
Moun ng Washer and Clamp Plate.
The Washer has a self‐adhesive gasket
on one face. Remove the backing
paper and posi on the Washer against
the underside of the bench aligned
concentric to the drilled hole.
Fit the Base Ring and sealing O‐Ring to
the tap as shown.
Pass the tap communica ons cable
through the bench hole and mount
the tap in posi on on bench ensuring
the sealing O‐Ring is si ng in the
groove of the Base Ring.
Fit the Clamp Plate on to the tap stud
and screw the Clamp Nut onto the
stud to secure the tap to the bench.
In ghtening the Clamp Nut, ensure
that the communica ons cable is free
and not pinched.
Refer to page 7 for the connec ons
between the Dispensing Tap and
Underbench Appliance.
SinkFree & Extended
Taps
If a Sink Free or Extended Tap Kit has
been supplied for installa on, refer to
the separate installa on instruc ons
supplied with the kit.
4
Base Ring
Ø52mm
Bench
max 50mm
Washer clearance
Ø75mm
Vent
Unmarked pipe
Boiling water
Red pipe
Tap Signal
8 pin header
Base Ring
O‐Ring
Bench hole
Ø35mm
Washer
Clamp Plate
Clamp Nut
Filtered/chilled water
Blue pipe
Adaptor fi ng
Filtered/Chilled water