Yamaha UB99A Service Manual page 17

4. Factory Set
Turn off power, and the inspection is now completed. If you
reset UB99A/ UB99B/ UB99MK2 to the factory default setting,
all of the batch contents you saved are erased. Take notes of
the settings, or save the settings on your computer, if
necessary (See page 22).
4-1. Turn on power while pushing [ON/OFF] or [AUTO
F.R./ON/OFF] SW and [STORE/EXIT] SW. The
following display appears.
@@FACTORY@@SET
@NO:[-]@YES:[+]
4-2. Push [+] SW. The following display appears.
@@FACTORY@@SET
SURE?PUSH[STORE]
4-3. Push [STORE/EXIT] SW. The following display
appears.
@@FACTORY@@SET
NOW@FACTORY@SET!
Then, the display is changed as follows.
@@FACTORY@@SET
@@@COMPLETE!!@@@
The Factory Set is completed.
Then, "5.Opening" display will appear and operation
returns to a normal condition.
4-4. At the time of cancellation, the following display
appears.
@@FACTORY@@SET
@@@CANCELLED!@@@
5. Opening
• In this mode, the following display appears.
@@@MAGICSTOMP@@@
@@@@@V2.00
(This picture shows an example of UB99MK2.)
* "V2.00" indicates the version of the firmware. This
number is subject to change due to the specification
change.
Then, the display is changed as follows.
@\
WAIT@A@MOMENT...
Finally, the display is changed as follows.
U01)HeavyHiGain
@@GAIN@MSTR@TONE
(This picture shows an example of UB99MK2.)
Turn off power and finish the procedure.
UB99A/UB99B/UB99MK2
17