User-Entered Calibration,
8. After entering A0, press
display.
9. Repeat steps
pair in the calibration curve
Note:
After A1 is entered, Add will appear in the display. If additional data pairs are
to be entered, press
10. When all the calibration data has been entered, press
to the measurement mode.
Editing a User-entered or Factory Calibration Curve
1. Press the
MENU
followed by "CAL". Press
Note:
If the meter does not display USER followed by CAL after pressing the
key, the factory calibration cannot be modified on this channel.
MENU
2. Press the
READ/ENTER
"S0" will appear in the display.
READ/ENTER
5
through
8
for each standard value and absorbance value
READ/ENTER
key and hold it down until the display shows "USER",
ZERO/SCROLL
key to enter Edit mode. In factory-calibrated meters,
continued
to accept. "S1" will appear on the
and continue with step 9.
until EDIT appears.
2—22
twice to return
MENU