Table of Contents
Advertisement
OTHER SHOOTING FUNCTIONS
Using the zoom
There are two zoom functions: optical zoom and digital zoom.
1
Make the zoom setting (see page
109), and point the camera lens at
the subject.
2
Press [T] or [W] on the zoom switch
to compose the desired image.
[T]: Zoom in on the subject.
[W]: Zoom out.
œ When the zoom switch is pressed,
the zoom bar appears on the LCD
monitor.
œ When the optical zoom factor is at
maximum, zooming stops
temporarily. When [T] on the zoom
switch is pressed again, the mode
changes to the digital zoom mode
and zooming continues (if digital
zooming is enabled).
3
Press the shutter release button.
NOTE
œ The digital zoom cannot be used when you are shooting without using the
LCD monitor.
œ During video clip recording when shooting in the BASIC mode, the optical
zoom does not operate; however, it may be possible to use the optical
zoom when shooting in the EXPERT mode (see page 109).
Zoom switch
LCD monitor
Zoom bar
When both optical
and digital zoom
are enabled
Optical zoom
Digital zoom (yellow)
When optical zoom
only is enabled
[ ]
[ ]
Pointer
66
English
Advertisement
Table of Contents
