Sanyo PLC-XU70 Owner's Manual page 55

Some displays are not seen
during the operation.
PIN code dialog box appears at start-up.
Computer 2 cannot be selected.
The Terminal function cannot be selected. –The Terminal function cannot be selected after Computer 2 is
The Remote Control does not work.
Cooling fans are still running after
the AC plug is disconnected.
WARNING :
High voltages are used to operate this projector. Do not attempt to open the cabinet.
If problems still persist after following all operating instructions, contact the dealer where you purchased the
projector or the service center. Give the model number and explain about the problem. We will advise you
how to obtain service.
The CE Mark is a Directive
conformity mark of the European
Community (EC).
Pixelworks ICs used.
–Check the Display function. (See page 41.)
–PIN code lock is being set. Input a PIN code (1234 or
numbers you have set). (See page 18, 46, 47.)
–Select Computer 2 at the Terminal function. (See page 44.)
selected. Select other input source such as Computer 1 or
Video with the INPUT button on the top control, the
COMPUTER button or the VIDEO button on the remote
control so that the Terminal function can be selected.
–Check the batteries.
–Make sure no obstruction is between the projector and
remote control.
–Make sure you are not too far from the projector when using
the remote control. Maximum operating range is 16.4' (5m).
–Make sure the code of the remote control is conformed to
the projector. (See page 45.)
–Unlock Key lock for the remote control in the Key lock
function. (See page 46.)
–This is normal condition. Fans are running about 1
minute even after disconnecting the AC plug.
This symbol on the nameplate means the product
is Listed by Underwriters Laboratories Inc. It is
designed and manufactured to meet rigid U.L.
safety standards against risk of fire, casualty and
electrical hazards.
Appendix
55