NOTE :
1. Please refer to
panel and understand the display meaning.
2. Please refer to
to understand how to use the UPS interfaces.
6.1 Start-up Procedures
After the UPS is connected to the AC utility, the AC utility supplies power to the
UPS. The UPS is initially set in 'STANDBY mode'. To turn on the UPS, press and
hold the
button for 3 seconds and release it after you hear one beep.
ON
6.2 Shutdown Procedures
and the UPS will transfer to standby mode.
The UPS will keep charging the batteries when the UPS is in standby mode
even though the
advised to unplug the power cord.
output.
6.3 Cold Start
Even when there is no utility power, you can still turn on the UPS. Just press and
hold the
button for 3 seconds, release it after you hear one beep, and the UPS
ON
will start up and run in battery mode.
6.4 Silence Function
If the buzzer is on, press the
occurs, the buzzer will be turned on again.
Chapter 6 : Operation
button has been pressed. To fully turn off the UPS, it is
OFF
to learn how to operate the operation
and
41
Chapter 6
Operation
button
OFF
button
OFF