Additional Information; Changing The Digital Security Code; Installing The Beltclip - Sanyo CLT-5810 Instruction Manual

UP015DH(CLT5810) ENG OM
ADDITIONAL

Changing the digital security code

The digital security code is an identification code used to connect the
handset and the base unit. Normally, setting the code is not
necessary. The first time you charge your handset, the security code
is automatically set.
In rare situation that you suspect another cordless telephone is using
the same security code, you can change the code.
1
Remove the handset from the base unit. Press and hold the PAGE
key on the base.
2
While holding the PAGE key, place the handset in the base unit,
and leave it there for more than 3 seconds. A new random
security code is set.
Note:
If the handset battery pack is completely discharged or the battery pack is
removed, the digital security code will be lost. If this happens, a new security
code is set automatically the next time the battery pack is charged.

Installing the beltclip

To attach the beltclip
Insert the beltclip into the holes on each side of the handset.
Press down until it clicks.
To remove the beltclip
Pull both sides of the beltclip to release the tabs from the holes.
E36
3/9/05 10:38 AM Page 36
INFORMATION