Sanyo KH2442 / CH2442 Service Manual page 182

(F) Confirm and change the indoor unit address (Ref. Fig. IV-8, IV-9)
The purpose of the above function is to let you confirm the indoor unit address after
the auto. address operation, and change the indoor unit address if it is needed.
a Press the
b Select the R.C. No. which you want to change with the
buttons.
c Press the
The smallest registered indoor No. and the selected R.C. No. will be displayed.
d Select the indoor No. which you want to change with
the fan motor of selected indoor unit will turn on and let you confirm the indoor unit
address.
Section
e Set the required new indoor unit's No. by pressing the
1
f Press the
UNIT No, SET DATA (0001) and
g If you made a mistake, press the
h Finally, press the
2
i If you want to change the indoor unit address of the other R.C. No., follow the step a to h
in the same way.
3
4
a
5
and ( ) buttons at the same time for more than 4 seconds.
button (to confirm the R.C. No.).
button.
button.
c b
1932_M_I
Fig. IV-8
,
changes from flashing to ON state.
button.
h
e
f
IV - 26
4. Service procedures
(up) or (down)
button. Once in this mode,
( ) button.
2077_M_I
Fig. IV-9
SM830082