Sanyo Xacti VPC-HD1010GX Instruction Manual page 125

HINT
If the motion compensation does not seem to be working...
i Due to the mechanical characteristics of this function, it may not be
possible for the camera to compensate for violent motion.
i If the digital zoom (page 81) is being used, the large magnification factor
may make it difficult for the motion compensation function to work correctly.
Can't set the "photo stabilizer" setting?
i The photo stabilizer is automatically turned off ] after any of the
following operations.
h Pressing the flash button [?] to open the flash unit.
h Setting the exposure to T, g or H (page 114).
h Setting the photo wide D-range setting (page 117) to "ON".
h Setting the still image NR (noise reduction) setting (page 153) to "ON".
h Setting the flicker reduction setting (page 156) to "ON".
h Starting video clip recording.
h Setting the camera to the sequential shots mode (page 95).
When motion compensation is enabled,
i The following icons are shown on the monitor:
Full-HD
00:04:30
Did the scene select setting change?
i When the motion compensation is set to \, if the scene select setting is
/, + or Q, it will automatically change to =.
The movie stabilizer is active
The photo stabilizer is active
Both the movie stabilizer and the photo stabilizer
are active
106
English