Component Access And Removal - Wolf CTG Series Service Manual

Component Access & Removal

COMPONENT ACCESS AND REMOVAL

This section explains how to access and remove components from a Wolf Gas Cooktop. Depending on which com-
ponent you are going to access or remove in the following sections, you may have to remove other components first.
Refer to the appropriate section in this manual that explains how to access and remove those various components.
When reassembling, just reverse the steps that were used to access and remove the components.
NOTE: Before attempting to access or remove any components from a Wolf Appliance, take note of the following
warnings.
• TO AVOID SERIOUS BURNS AND/OR EXPLOSIONS, KEEP COMBUSTIBLES AWAY FROM THE APPLIANCE
WHENEVER A FLAME IS PRESENT. REMEMBER THAT SURFACES AND COMPONENTS GET HOT DURING
THE USE OF THE APPLIANCE.
• TO AVOID ELECTRICAL SHOCK, POWER TO THE UNIT MUST BE DISCONNECTED WHENEVER ACCESS-
ING AND/OR REMOVING COMPONENTS POWERED BY ELECTRICITY OR COMPONENTS NEAR OTHER
ELECTRICAL COMPONENTS.
• TO AVOID HAZARDOUS EXPLOSION OR GAS LEAKS, GAS TO UNIT MUST BE TURNED OFF AT THE GAS
SUPPLY SOURCE WHENEVER ACCESSING AND/OR REMOVING COMPONENTS.
• TO ENSURE PROPER BURNER OPERATION, THE O-RINGS MUST BE REPLACED ANY TIME THE UNIT IS
DISASSEMBLED FOR ANY REASON.
• WHEN REASSEMBLING GAS SUPPLY LINE TO REGULATOR, ONLY PIPE THREAD COMPOUND SHOULD
BE USED. DO NOT USE TEFLON TAPE TO SEAL GAS PIPE CONNECTIONS.
• WHEN REASSEMBLING REGULATOR TO MANIFOLD, ONLY PIPE THREAD COMPOUND SHOULD BE USED.
DO NOT USE TEFLON TAPE TO SEAL GAS PIPE CONNECTIONS.
#802985 - Revision E - August, 2011
Gas Cooktop (CTG) Series
Gas Cooktop (CTG) Series
4-2