Verify Anti-Tip Bracket Is Installed And Engaged - Whirlpool WFG500M4H Installation Instructions Manual

Complete Connection
1. Check that the gas pressure regulator shutoff valve is in the
"on" position.
A. Gas pressure regulator shutoff valve shown
in the "on" position
2. Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
A
A. Closed valve
B. Open valve
3. Test all connections by brushing on an approved
noncorrosive leak-detection solution. If bubbles appear, a
leak is indicated. Correct any leak found.
4. Remove cooktop burner caps and grates from parts
package. Burner caps should be level when properly
positioned. If burner caps are not properly positioned,
surface burners will not light. Place burner grates over
burners and caps.
B
A
A. Burner base
B. Burner cap
C. Burner grate
A
B
5. Plug into a grounded 3 prong outlet.
6. Slide range into final location, making sure the rear leveling
1. Place the outside of your foot against the bottom front
C
2. Slowly attempt to tilt the range forward.
3. If the rear of the range lifts more than ½" (1.3 cm) off the floor
IMPORTANT: If there is a snapping or popping sound when
lifting the range, the range may not be fully engaged in the
bracket. Check to see if there are obstructions keeping the range
from sliding to the wall or keeping the range foot from sliding
into the bracket. Verify that the bracket is held securely in place
by the mounting screws.
4. Slide the range forward, and verify that the anti-tip bracket is
5. Slide range back so the rear range foot is inserted into the
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
leg slides into the slot of the anti-tip bracket.
Verify Anti-Tip Bracket Is Installed and
Engaged
of the drawer, and grasp the lower right or left side of the
backguard as shown.
NOTE: If your countertop is mounted with a backsplash, it
may be necessary to grasp the range higher than is shown in
the illustration.
If you encounter immediate resistance, the range foot is
engaged in the anti-tip bracket.
without resistance, stop tilting the range and lower it gently
back to the floor. The range foot is not engaged in the anti-
tip bracket.
securely attached to the floor or wall.
slot of the anti-tip bracket.
9