Bluetooth - Connection; Pair And Connect A Bluetooth Device For The First Time - JVC KD-T905BTS Instruction Manual

BLUETOOTH®
Depending on the operating system and the
firmware version of your mobile phone, Bluetooth
features may not work with this unit.
BLUETOOTH — Connection
Supported Bluetooth profiles
– Hands-Free Profile (HFP)
– Advanced Audio Distribution Profile (A2DP)
– Audio/Video Remote Control Profile (AVRCP)
– Serial Port Profile (SPP)
– Phonebook Access Profile (PBAP)
Supported Bluetooth codecs
– Sub Band Codec (SBC)
– Advanced Audio Coding (AAC)
Connect the microphone
Rear panel
Microphone (supplied)
Microphone input jack
Adjust the microphone
Secure using cord clamps (not
angle
supplied) if necessary.

Pair and connect a Bluetooth device for the first time

Press B SRC to turn on the unit.
1
2 Search and select the name of your receiver ("KD-T9
"KD-T7 BT"/"KD-TD9 BTS"/"KD-TD7 BT"/"KD-SR8 BT") on the Bluetooth device.
"BT PAIRING" flashes on the display.
• For some Bluetooth devices, you may need to enter the Personal Identification Number (PIN)
code immediately after searching.
3
Perform (A) or (B) depending on what appears on the display.
For some Bluetooth devices, pairing sequence may vary from the steps described below.
(A) "Device Name" "XXXXXX"
"XXXXXX" is a 6-digit passkey randomly generated during each pairing.
Ensure that the passkeys appear on the unit and Bluetooth device are the same.
Press the volume knob to confirm the passkey.
Operate the Bluetooth device to confirm the passkey.
(B) "Device Name" "VOL – YES"
Press the volume knob to start pairing.
• If "PAIRING" "PIN 0000" scrolls on the display, enter the PIN code "0000" into the
Bluetooth device.
You can change to a desired PIN code before pairing. (Page 19)
• If only "PAIRING" appears, operate the Bluetooth device to confirm pairing.
"PAIRING COMPLETED" appears when pairing is completed and "O" will light up when the Bluetooth
connection is established. For KD-T905BTS/KD-T900BTS/KD-T805BTS/KD-TD90BTS, the battery and
signal strength of the connected Bluetooth device is shown (see [FORMAT] on page 30).
• This unit supports Secure Simple Pairing (SSP).
• Up to five devices can be registered (paired) in total.
• Once the pairing is completed, the Bluetooth device will remain registered in the unit even if you
reset the unit. To delete the paired device, see [DEVICE DELETE] on page 19.
• A maximum of two Bluetooth phones and one Bluetooth audio device can be connected at any
time.
However, while in BT AUDIO source, you can connect to five Bluetooth audio devices and switch
between these five devices. (Page 21)
BTS"/"KD-T8
"VOL – YES" "BACK – NO"
"BACK – NO"
BTS"/
15
ENGLISH