Desa 100,000 Btu/Hr Owner's Manual page 7

7. Assemble wheel axle into front holes of
legs (see Figure 7).
8. Secure front legs to tank with two bolts
(C) (see Figure 8).
9. Tighten bolts from step 4 securing legs to
rear cross support.
10. Set heater down to floor on wheel and rear
legs.
Figure 7 - Installing Wheel and Axle
Figure 8 - Attaching Legs to Tank
118419-01E
aSSemBly
Continued
11. Slide rear handle onto each end of front
handle. Insert bolts (D) into holes (2 per
side) (see Figure 9).
12. Lift handle assembly over heater. Align
and guide bolts into holes in leg.
13. Secure assembly with nuts (E) (see
Figure 10).
14. Tighten entire assembly with tools.
Wheel
Leg
Front
Handle
Figure 9 - Front and Rear Handle
Bolt (C)
Figure 10 - Handle and Leg Assembly
www.desatech.com
Rear
Handle
Assembly
Handle Assembly
Leg
Nut (E)
Bolt (D)
7