Table of Contents
Advertisement
Table 6- 5
Maximum voltage peaks at the motor terminals for line (DOL) motors, converter operation possible
Rated motor voltage
V
≤ 500 V
Table 6- 6
Maximum voltage peaks at the motor terminals for motors specifically designed for converter operation (e.g.
VSD 10)
Rated motor voltage
V
≤ 500 V
> 500 V to 690 V
See also
Further documents (Page 140)
6.8
Final checks
Before closing the terminal box/terminal base of the machine enclosure, check the following:
● Establish the electrical connections in the terminal box in accordance with the information
in this documentation.
● Maintain the air clearances between non-insulated parts as described in Chapter
Minimum air clearances. (Page 66)
● Avoid protruding wire ends.
● In order not to damage the cable insulation, freely arrange the connecting cables.
● Connect the machine corresponding to the specified direction of rotation.
● Keep the inside of the terminal box clean and free from trimmed-off ends of wire.
● Ensure that all seals and sealing surfaces are undamaged and clean.
● Correctly and professionally close unused openings in the terminal boxes. Observe the
information in this documentation.
● Observe the information on torques in this documentation.
See also
Tightening torques for screw and bolt connections (Page 141)
Standard motors SH 63 ... 355
Operating Instructions, 12/2018, A5E38483075A
Maximum peak voltage at the motor terminals
Û
Û
Û
phase-to-phase
phase-to-ground
V
pk
1500
900
Maximum peak voltage at the motor terminals
Û
Û
Û
phase-to-phase
phase-to-ground
V
pk
1600
1000
2200
1000
dependent on the rise time t
max
Rise time t
V
pk
1100
0.5
900
0.1
dependent on the rise time t
max
Rise time t
V
pk
1400
0.5
1000
0.1
1800
0.5
1000
0.1
Electrical connection
6.8 Final checks
r
DC link U
r
μs
V
750
r
DC link U
r
μs
V
750
1080
DC
DC
73
Advertisement
Table of Contents
