Spark Plug; Cooling System - Echo PB-8010 H Operator's Manual

MAINTENANCE

Spark Plug

Level 2.
Parts Required: TUNE-UP KIT
Use only NGK CMR7H spark plug otherwise severe engine damage
may occur.
1. Remove spark plug and check
for fouling, worn and rounded
center electrode.
2. Clean the plug or replace with a
new one. DO NOT sand blast to
clean. Remaining sand will
damage engine.
3. Adjust spark plug gap by
bending outer electrode.
4. Tighten spark plug to 102-153 kgf • cm (86-133 in • lbf).

Cooling System

Level 2.
To maintain proper engine operating temperatures, cooling air must
pass freely through the cylinder fin area. This flow of air carries
combustion heat away from the engine.
Overheating and engine seizure can
occur when:
• Air intakes are blocked,
preventing cooling air from
reaching the cylinder.
• Dust and grass build up on the
outside of the cylinder. This build
up insulates the engine and
prevents the heat from leaving.
38
PB-8010 H/T
0.65 mm (0.026 in.)
X7501200001
© 11/2018 ECHO Inc.