Operation:
NOTE
How to stop the air
conditioner:
How to restart the air
conditioner:
CAUTION
6
Control Panel and Operation
Functions (continued)
THERMOSTAT
(setting temperature guide)
Cooling Only Model
COOLER
1. Set the mode selector for fan, cooling or heating operation.
2. Set the thermostat to the desired position. (Refer to the setting
temperature guide above.)
3.
Set the operation selector switch.
The above temperatures are provided for reference only, and may differ
from the actual temperature of the room.
To stop the air conditioner, set the mode selector to OFF position.
To restart the air conditioner, set the mode selector to desired position.
1)
If the unit is turned off during cooling and heating, DO NOT restart it
immediately, as this can damage it. Wait at least three minutes before
starting
it again.
2) Freezing Up:
If you notice that your air conditioner is not cooling as it should, it may
be that ice has formed on the cooling coils. The ice blocks air flow and
stops the unit from cooling the room. This "freezing up" is a temporary
condition that most often occurs at night when the Thermostat is set on
the coldest setting and the Selector is set on LOW COOL.
To correct the condition set the Selector at (H or L) FAN or HIGH COOL
with the Thermostat with turning the thermostat knob to the opposite
direction from "COOLER".
Cool/Heat Model
(55 F)
(88 F)
WARMER
(55 F)
COOLER
OI-602-06EG