Know Your Product; Residual Risks; Symbols On The Product - Ryobi RLS2200T5 Original Instructions Manual

WARNING
Servicing requires extreme care and knowledge
and should be performed only by a qualified service
technician. For service we suggest you return the
product to your nearest authorised service centre for
repair. When servicing, use only identical replacement
parts.
■ You may perform maintenance tasks described in
this manual. For repairs, return the log splitter to an
authorised service centre.
WARNING
Hydraulic oil at high pressure is dangerous. Never turn
on the machine if oil is leaking.
■ Disconnect the product from the power source
before cleaning, making adjustments, or conducting
maintenance work on the product.
■ Before each use, check the product for oil leaks and
other damage. Do not use the log splitter until oil leak or
damage has been professionally repaired.
■ Keep the product clean, particularly in the splitting area
and around the motor to ensure adequate ventilation.
Use a soft brush for cleaning.
■ Before each use, check the oil level and fill if necessary
using hydraulic oil. Follow the procedure shown in the
Getting started section.
■ The manufacturer recommends to change the hydraulic
oil every 150 hours of use, or if the oil appears dirty or
contaminated while checking the oil level.
■ To improve efficiency, regularly check that the fixed
wedge is not damaged. You may file the edge of the
fixed wedge as shown in the graphical maintenance
section of this manual. If the fixed wedge is too badly
damaged, bring the product to an authorised service
centre for a replacement fixed wedge.

RESIDUAL RISKS

Even when the product is used as prescribed, it is still
impossible to completely eliminate certain residual risk
factors. The following hazards may arise in use and the
operator should pay special attention to avoid the following:
■ Foot injury from falling debris. Follow size and shape
limits. Wear protective footwear.
■ Injury caused by entrapment between fixed and moving
parts. Keep hands and all body parts away from moving
parts. Only one person allowed to load and operate the
machine.
WARNING
Injuries may be caused, or aggravated, by prolonged
use of the product. When using any tool for prolonged
periods, ensure you take regular breaks.

KNOW YOUR PRODUCT

See page 6.
1. Hydraulic ram
2. Fixed wedge
3. Log supports
4. Moving pressure plate
5. Direction control lever
6. Control box
7. Bleed screw
8. On/Off button
9. Dipstick with oil drain bolt

SYMBOLS ON THE PRODUCT

Read and understand all instructions
before operating the product, follow all
warnings and safety instructions.
The log splitter must be always
operated by one person only. Keep all
bystanders, especially children and
pets away from the operating area.
Wear eye protection.
Wear non-slip safety footwear when
using the product.
Wear non-slip, heavy-duty gloves.
Beware of electric shock hazard.
Remove plug from the mains
immediately before maintenance or if
cable is damaged or cut.
Do not place your hand between the
fixed wedge and the log
Do not expose the product to rain or
damp locations.
Remove plug from the mains
immediately before maintenance or if
cable is damaged or cut.
Loosen the wing nut during use for 1 to
2 turns. Retighten during transport.
Regulatory Compliance Mark (RCM).
Product meets applicable regulatory
requirements.
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authority or
retailer for recycling advice.
3