Sansui HDLCD3200A Owner's Manual page 21

TV operation
CH A/V
Press and release CH A or V. The channel
automatically stops at the next channel set
into memory.
For proper operation, before selecting
channels, they should be set into the memory.
See pages 18 and 19 "Memorizing channels".
ANT
ABCD
CABLE
ANALOG 1 2
DISPLAY
Press DISPLAY to display the current information on the screen.
When the TV receives a digital signal, the
digital information will appear.
, Channel number
, Broadcast program name
, Station name , Remaining time
, Audio language , Program guide
, V-CHIP RATING , V-Chip mark
, Sleep time , Picture size
When the TV receives a analog signal, the
analog information will appear.
, Channel number or VIDEO mode selected
, Channel label (if preset)
, Stereo or SAP (second audio program)
audio status
Content rating
Sleep time
, Picture size
|
Press DISPLAY again to clear the call display.
NOTES:
• The TV is capable of holding a still
video image or On screen display
image on your TV screen indefinitely. If
you leave the still video image or On
screen display image displayed on
your TV for an extended period of
time, you risk permanent damage to
your TV screen.
• When the TV receives an analog
signal, DISPLAY shows only analog
information.
• After 10 seconds, DISPLAY screen will
return to normal TV-operation auto-
matically, when a Digital signal is
received.
After 4 seconds, DISPLAY screen will
return to normal TV-operation auto-
matically, when a Analog signal is
received.
QUICK VIEW
This button allows you to go back to the last
channel selected by pressing QUICKVlEW.
Press QUICK VIEW again to return to the last
channel you were watching.
MUTE
Press MUTE to switch off the sound. The TV's
sound will be silenced and "MUTE" will briefly
appear on the screen. The sound can be
switched back on by pressing this button again
or the VOL + or -.
ANT
ABCD
CABLE
ANALOG 1 0
SLEEP
To set the TV to turn off after a preset amount
SLEEP TIMER
of time, press SLEEP on the remote control ........
The clock will count up 10 minutes for each
press of the SLEEP button (OFF, 0hl0m .....
lh50m, 2h00m). After the sleep time is
programmed, the display will appear briefly
every ten minutes to remind you that the sleep
timer is operating. To confirm the sleep timer setting, press SLEEP and the
remaining time will be displayed for a few seconds. To cancel the sleep timer,
press SLEEP repeatedly until the display turns to OFF.
21