How To Repaint The Product; Pretreatment Of Parts - Axis Q1785-LE Repainting Instructions

AXIS Q17 Series

How to repaint the product

How to repaint the product
Preparations
• If applicable, disassemble the equipment according to the instructions in this document.
• Clean all parts to be repainted thoroughly to remove grease, dust, or oil.
• To ensure reassembly and functionality of the product, mask openings for screws, LED indicators, or microphones before
painting.

Pretreatment of parts

Depending on the part material and type of paint applied at factory, different pretreatment should be done for the new paint to
adhere as well as possible. Clean the parts properly to remove oil, grease and dust.
For more information on the materials used in the product, see its datasheet at www.axis.com
Powder coated parts - Use a primer. Alternatively, remove the original powder coating down to the base material, using fine
sandpaper, and clean the parts before painting.
Anodised and chromated parts - Use a primer.
Uncoated stainless steel - No special pretreatment is needed, but make sure that the surface is clean before painting.
Plastic - Use a primer.
Disassembly
1 Lid
2
Screw
1. Remove the screw and the lid from the foot.
3