How To Add The Fabric Softener; How To Put The Detergent In; Water Supply Connector Filter; Cleaning The Filter - Samsung DC68-02040A-01 User Manual

■

HOW TO ADD THE FABRIC SOFTENER

•
When a proper amount (one time does) of fabric softener is
stored in the softener inlet, it is automatically put in at the last
rinsing cycle.
•
Do not use detergent, bleach or starch into the Softener Inlet.
•
Using too much softener (more than 40CC) may
produce unsatisfactory results.
•
Do not open the lid during the Spin Dry cycle. If
added too early, its effectiveness will decrease.
•
Do not leave the softener into the Softener.
Dispenser for a long time. Because softner
became stiff.
■

HOW TO PUT THE DETERGENT IN

1. Open the detergent box by pulling in the direction of the arrow as shown in
the figure and then put the powder detergent in the detergent box.
2. Put in one-time amount of detergent evenly so the detergent may not brim
over the box.
Detergent Device
Put the
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
detergent in proportion
to Water level
Softener Device
Softener
baseline
CAUTION : If softener is stored over the above base line, it may flow down at
any time.
■
WATER SUPPLY CONNECTOR FILTER
1. Pull out the filter and 2. Pull in the filter and
wash well. connect the hose to the
inlet water valve tightly.
inlet water
valve
3. Check if there is a
leakage.
Note to tighten up
the connector.
■
CLEANING THE FILTER
Clean the filter net often to keep the washer clean.
1. Push the upper part of the Magic
filter and pull in.
2. Open the cover as shown in the
figure.
3. Clean the Magic filter.
4. Close the cover and insert the
lower part of the filter in the
basket first and then push the
filter with click sound.
■
HOW TO CLEAN THE PUMP FILTER
1. Place a rag under the washer filter not to
wet the floor.
2. Rotate the filter counterclockwise and pull
out the filter.
3. Remove dirts and rotate the filter clockwise
until it locks in position.
- 11 -
1. Push up and pull out the filter net.
2. Remove the collected lint from the
filter net.
3. Clean the filter net.
4. Pull down the filter net.