Table of Contents
Advertisement
INSTALLATION & MAINTENANCE
The User's Manual is for common use.
Make use of the User's Manual depending upon your washing machine model.
■
ENVIRONMENT
Leave some space
Maintain at least 10cm between the washer and the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak surface, noise or vibration
occurs. (Allowable is 1°)
Adjust the legs for even placement.
Never install the washer near water.
Do not place the washer in steamy rooms or where the washer is directly
exposed to rain. Moisture may destroy the electrical insulation causing an
electrical shock hazard.
Avoid direct sunlight or heaters.
As plastic an electrical components are affected by direct heat, never place the
washer near furnaces, boilers, etc. Do not place under direct sunlight.
■
LEVELLING
•
If the washer is not leveled with the ground, it makes the machine tremble
more or be out of order. So, make sure that the washer is leveled properly.
SEE IF THE MACHINE IS PLACED LEVEL BY CHECKING
THE POSITION OF THE WASHING TUB.
•
Open the lid of the machine, pour
water into the tub up to the level just
below the pulsator, and adjust the legs
so that the pulsator is positioned at the
center of the water as shown in the
figure.
•
Place the machine more than 10cm away from the wall.
•
Adjust the legs on feet
Loosen
Lock
■
CONNECTING THE WATER SUPPLY HOSE
1.
Remove the adaptor from the water supply hose.
2.
First, using a "+" type screw driver, loosen the four
screws on the adaptor. Next, take the adaptor and turn
part(b) following the arrow for gap about 5mm between
them.
3. Connect adaptor to the water tap by tightening the screws
firmly. Then, turn part(b) following the arrow and put (a)
and (b) together.
4. Connect the water supply hose to the adaptor. Pull down
the part (c) of the water supply hose. When the part (c) is
released, the hose is automatically connected to the
adaptor making a 'click' sound.
5.
Connect the other end of the water supply hose to
the inlet water valve at the back of the washer.
Screw the hose clockwise all the way in.
5-1. Connect the other end of the water supply hose to
the inlet water valve at the top of the washer.
Screw the hose clockwise all the way in.
☞ If the water tap is a screw type, assemble a water
supply hose that fits to the tap as shown.
After completing connection, if water leaks from the hose, then
repeat the same steps.
Use the most conventional type of faucet for water supply.
In case the faucet is square or too big, remove the spacing ring
before inserting the faucet into the adaptor.
- 9 -
a
b
c
Hide quick links:
Advertisement
Table of Contents
