Installation & Maintenance; Environment; Assembling The Part Protection Panel; How To Assemble The Legs - Samsung WA70K2P User Manual

Table of Contents

Advertisement

gb-5kg-01320D
2/11/03 4:02 PM
Make use of the User's Manual depending upon your washing machine model.

ENVIRONMENT

Leave some space
Maintain at least 10cm between the washer and the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak surface,
noise or vibration occurs. (Allowable is 1˚)
Adjust the legs for even placement.
ASSEMBLING THE PRAT PROTECTION PANEL
Tilt the washer a little and lift up the panel until it clicks,
finally fix the panel with screw to the base as shown
in the figure.
REAR SIDE

HOW TO ASSEMBLE THE LEGS

1. Check the 4 Legs.(Front-right. Front-left.
Rear-right. Rear-left)
2. Lay down the Washing Machine to the front.
3. Insert the hook of leg in to the square hole
of base.
4. Push the leg to the arrow direction to "Click".
5. Finaly fix the legs on the base
with screw like a figure.

IN CASE OF PUMP-DRAINED WASHER

Take out the cap-hose and
Be sure to join tightly the drain hose into
connect the outlet-hose.
the drain-outlet on the back of the
machine.
cap-hose
outlet-hose

CONNECTING THE DRAIN HOSE

After pressing the joint ring(a), insert the drain hose(b)
to drain direction.
Page 8
INSTALLATION & MAINTENANCE
The User's Manual is for common use.
Never install the washer near water.
Do not place the washer in steamy rooms or where the
washer is directly exposed to rain.Moisture may destroy the
electrical insulation causing an electrical shock hazard.
Avoid direct sunlight or heaters.
As plastic and electrical components are affected by direct
heat,never place the washer near furnaces, boilers, etc.
Do not place under direct sunlight.
1.Insert the sound
2.If you have difficulty
7
absorbing panel
to the assembling
hole on back side
to the end.
inserting the panel
lift up the washer a
little and insert it
Hook
Hole
2
1
Base
Screw
Be sure to join tightly the drain
Install the drain hose in the
hose into the drain-outlet
position of about 70~80cm
on the side of the machine.
above the ground.
(a)
(b)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents