Intended Use; Residual Risk - Ryobi RBV26B Operator's Manual

the cinders are completely cool.

INTENDED USE

The product is only intended for use outdoors in a well
ventilated area.
The product is intended for blowing light debris including
leaves, grass and other garden refuse. It is intended to
vacuum and mulch light debris as above and collect in the
debris bag. It is not designed to suck or vacuum water or
other liquid.

RESIDUAL RISK

Even when the product is used as prescribed, it is still
impossible to completely eliminate certain residual risk
factors. The following hazards may arise in use and
the operator should pay special attention to avoid the
following:
■ Injury caused by vibration. Always use the right tool for
the job, use designated handles and restrict working
time and exposure.
■ Exposure to noise can cause hearing injury. Wear ear
protection and limit exposure.
■ Injury from flying objects from the blow tube airflow or
vacuum exhaust if the bag is not fitted or damaged.
SYMBOLS
Symbols Explanation
Read this safety and operating instructions
in this booklet and keep it in a safe place
for future reference.
Beware of thrown or flying objects. Keep
all bystanders at least 15 m away.
Wear eye protection
Wear ear protection
Do not run product without tubes in place.
Risk of long hair being drawn into air inlet.
Risk of loose clothing being drawn into air
intake.
To reduce the risk of injury or damage,
avoid contact with any hot surface.
Warning! Hot surface.
English (Original instructions)
3
Dangerous feed orifice. Rotating fans.
Keep hands and feet out of the openings
while the product is running.
Guaranteed sound power level is 107 dB.
107
Use unleaded petrol intended for motor
vehicle use with an octane rating of 91
([R+M]/2) or higher.
Use 2-stroke oil for air cooled engines.
Mix the fuel mix thoroughly and also each
time before refueling.
Full choke
Half choke
Run position
Blower mode
If the quick change lever is pointing on
this symbol, the product operates in blow
mode.
Vacuum mode
If the quick change lever is pointing on
this symbol, the product operates in
vacuum mode
Conforms to all regulatory standards in
the country in the EU where the product
is purchased.
EurAsian conformity mark
Ukrainian mark of conformity
To start a cold engine
To start a warm engine
2
1
4 5
x 10
7 8
1 2
x 10
3
6
9 10
3
4