5-5) Alarm Setup - Samsung SMO-210DN User Manual

1. DWELL TIME SETUP
- Pressing SEQUENCE button in Single Screen will bring up the SEQUENCE MODE. You may set
the time display for each channel. If you set zero (0) seconds as the DWELL TIME for a particular
channel, the set channel will be skipped and next channel will be shown. You may
set time in the QUAD-A, QUAD-B screens.
[0SEC, 1SEC, 2SEC, 3SEC.................... ~ 60SEC]
- Use

5-5) ALARM SETUP

• Function: Allows users to set the ALARM MODE for each camera.
• Setting method: Move to #6. ALARM MENU by using
press the ENTER SWITCH to display the OSD as shown in the figure below. (The figure shows
the initial setting status.)
ALARM
CAM1
CAM2
CAM3
CAM4
CAM5
CAM6
CAM7
CAM8
HOLD TIME
ALARM ON TIME
ALARM OFF TIME
ALARM TONE
(1) CAM1 to CAM8 item sets whether the alarm sensor connected to the camera is used or not.
(ON: Alarm function setting, OFF: Alarm function canceling)
(2) HOLD TIME item sets time to freeze alarm operation when alarm occurs.
(HOLD TIME to be set: 05SEC ~ 1MIN ~ 30MIN)
* Note : If you want to carry alarm operation, you must pre-set ALARM ON/OFF TIME item in
(3) ALARM TONE sets whether or not alarm tone (high-pitched tone)sounds when an ALARM or
VIDEO LOSS occurs.
(ON: ALARM TONE operation, OFF: Cancel)
, , , , key to make changes.
05/01/05
SETTING
ON
ON
ON
ON
ON
ON
ON
ON
05SEC
00:00
00:00
ON
monitor before CAMERA ALARM is set to ON. If you do not pre-set ALARM ON/OFF
TIME item in advance, alarm operation is not carried though CAMERA ALARM is set to ON.
00:00:01
English-5-7
KEY in the SETUP MENU, and