Check Amount Of Water; Installation Of Water Dispenser Line - Samsung RS275ACBPXAA Owner's Manual And Installation

INSTALLATION OF THE WATER DISPENSER LINE
Remove any residual matter inside the water supply line after installing the filter.
1) Turn on the main water supply & shut-off the valve of the
water supply line.
2) Run water through the dispenser until the water runs clear
(6~7 minutes). This will clean the water supply system and
clear air from the lines.
3) Additional flushing may be required in some households.
4) Open the refrigerator door and check if water leaks around
the water filter.
• A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser.
NOTE • Before reinstalling the water filter, remove the wine shelf (RS277).
Check the amount of water supplied to the ice tray.
1) Lift (①) and pull out (➁) the ice maker bucket in the freezer.
2) When you press the test button, the ice cube container is
filled with water from the water supply tap.
Check the amount of water (see the illustration below).
If the water level is too low, the ice cubes will be small.
This is not a problem with the ice maker but of the water pres-
sure in the pipe, and occurs frequently.
When this problem occurs, contact a
service person to check the amount of
water supplied.
3) In case ice doesn't come out, pull out
the ice bucket and press test button
located on the bottom of ice maker.
ICE
ICE MAKER
CHECK THE WATER LEVEL
TEST BUTTON
29
WATER
TOO HIGH
OPTIMUM
LEVEL
TOO LOW