Install The Water Filter - Samsung RS275ACBPXAA Owner's Manual And Installation

INSTALLATION OF THE WATER DISPENSER LINE
Connect the water line to the refrigerator.
- Remove the compressor cover of the refrigerator.
- Connect the water line to the valve, as shown in the figure.
- When connected, check if there is any leakage.
If any, re-seal the connection.
- Reattach the compressor cover of the refrigerator.
Secure the water line.
- Using clip "A", fix the water line to the wall or the back of refrigerator.
- When the water line is secure, make sure that the
water line is not excessively bent, pinched or squashed.
Complete the installation of the water supply line.
- Power on the refrigerator and press the lever on the right of the dispenser until water
runs out through the water line and all air has been cleared from the water line.
- At this time, check for any possible leakages at the joints in the water line.
After securing the water line, move the refrigerator to the required location.
Once the refrigerator is in position, do not move it if possible..

Install the water filter.

1) Remove the fixed cap (A) as shown. the fixed cap can be separated
from the Water Filter Compartment by rotating it counterclockwise.
Remove the water filter from the box and put a month indicator
sticker on the filter as shown.
Keep the cap(A) in a safe place for the future (to put it
back in place when you don't need to use the filter).
NOTE
2) If the water filter was installed in March, put on the "SEP" sticker.
3) Remove the Red protective cap from the filter, then position and
insert the filter as shown.
4) Slowly turn the water filter clockwise 90º to align
the indication mark on the cover, locking the filter in
position. Do not overtighten.
SEPARATION
OF RED CAP
STICKER
(MONTH INDICATION)
Please check that the indication line aligns with the lock position.
NOTE
WATER LINE
28
CONNECTION NUT
COMPRESSOR COVER
OF REFRIGERATOR
CLIP A
WATER LINE
(A)
COVER FILTER
ALIGN THE INDICATION MARK
WITH LOCK POSITION.