Ii5 - Curtis CAFE0AP10A000 User Manual

INSTALLATION INSTRUCTIONS
NOTICE - This brewer is shipped with the
thermostat turned ON. DO NOT plug in the
brewer before pouring 3 pots/192 oz. of water
into the opening as instructed below; damage to
the heating element and/or thermostat will result.
Installation
Leveling
WARNING: Use the leveling legs to level the
brewer only. Do not use them to adjust brewer
height. Do not extend them higher than
necessary.
1 Position the brewer on the countertop near an
electrical outlet that meets the SPECIFICATIONS.
Level the brewer left to right and front to back by
turning the bottom of the legs.
Connecting the Brewer Power Plug - Export Units
2 Connect the appropriate type of grounded power plug
to the end of the power cord coming from the back of
the unit.
Prepare the Brewer for Use
3 Place an empty glass decanter on the warmer deck,
under the spray head.
4 Insert the empty brew basket into the brew rails of the
brewer, below the control panel.
5 Fill the water tank by slowly pouring room temperature
water through the opening on the top cover, until
water starts running in a steady stream from the
brew basket. It takes approximately three pots or 192
of the brew basket.
CAFE, INSTALLATION INSTRUCTIONS

II5

121217B