Samsung RM255AB series Owner's Manual And Installation page 23

ADJUSTING THE HEIGHT BETWEEN THE DOORS
If the Arctic Select Zone Door is lower than the Fresh Select Zone Door.
Arctic Select Zone
1) Locate the height-adjuster (➀) in the Arctic Select Zone.
Unscrew the four phillips screws (➁) slightly to loosen the door.
➀
2) Unscrew the adjuster-phillips screw ( ➂ ) two turns to rotate the adjuster.
3) Find the best adjuster-level to align the door gap.
After adjustment, tighten the screws (
The adjuster in the Fresh Select Zone can be used in the same way.
NOTE
adjustment part
Fresh Select Zone
➁
➂
CASE) The gap is about 2mm (0.08inch) as shown below.
gap
Arctic Select Zone Door Fresh Select Zone Door
reference plane
- Rotate down the adjuster-face with
- The number of the adjuster to rotate depends on the gap.
➁ & ➂ ) in reverse order.
23
+ 2.0 number to reduce the door gap.