Troubleshooting - Kenwood KMM-205 Instruction Manual

TROUBLESHOOTING

Symptom
Sound cannot be heard. • Adjust the volume to the optimum level.
• Check the cords and connections.
"MISWIRING CHECK WIRING
THEN PWR ON" appears.
"PROTECTING SEND SERVICE"
appears.
Source cannot be selected.
• Sound cannot be heard.
• The unit does not turn on.
• Information shown on the
display is incorrect.
The unit does not work at all.
Correct characters are not • This unit can only display uppercase letters, numbers,
displayed.
• Depending on the display language you have selected
• Radio reception is poor.
• Static noise while listening
to the radio.
Playback order is not as
intended.
Elapsed playing time is not
correct.
"READING" keeps flashing. • Do not use too many hierarchical levels and folders.
• Reattach the device (USB/iPod/iPhone).
The iPod/iPhone does not • Check the connection between this unit and iPod/iPhone.
turn on or does not work. • Disconnect and reset the iPod/iPhone using hard reset.
Remedy
Turn the power off, then check to be sure the terminals of
the speaker wires are insulated properly. Turn the power
on again.
Send the unit to the nearest service center.
Check the [SOURCE SELECT] setting. (Page 5)
Clean the connectors. (Page 13)
Reset the unit. (Page 3)
and a limited number of symbols.
(page 5), some characters may not be displayed
correctly.
Connect the antenna firmly.
The playback order is determined by the order in which
file name were recorded (USB).
This depends on the recording process earlier (USB).
Symptom Remedy
"LOADING" appears when This unit is still preparing the iPod/iPhone music list. It
you enter search mode by may take some time to load, try again later.
pressing .
"NA FILE" Make sure the media (USB) contain supported audio files.
(Page 13)
"COPY PRO" A copy-protected file is played (USB).
"NO DEVICE" Connect a device (USB), and change the source to USB
again.
"NO MUSIC" Connect a device (USB) that contains playable audio files.
"iPod ERROR" • Reconnect the iPod.
• Reset the iPod.
• Sound cannot be heard • Reconnect the Android device.
during playback. • Launch any media player application on the Android
• Sound output only from device and start playback.
the Android device. • Relaunch the current media player application or use
another media player application.
• Restart the Android device.
• If this does not solve the problem, the connected
Android device is unable to route the audio signal to unit.
(Page 13)
• If USB connection does not work, connect the Android
device through auxiliary input jack.
"NO DEVICE" or "READING" • Reconnect the Android device.
keeps flashing. • If USB connection does not work, connect the Android
device through auxiliary input jack.
Playback is intermittent or Turn off the power saving mode on the Android device.
sound skips.
"NO MUSIC"/"ANDROID • Make sure Android device contains playable audio files.
ERROR" • Reconnect the Android device.
• Restart the Android device.
15
ENGLISH