Table of Contents
Advertisement
AIP 6350 / Office 35IP
Proceed as follows to carry out an initialization:
1. Initiate a restart. The boot procedure is initiated.
2. Press simultaneously the key
the boot procedure. Hold the key until the display reads "Set factory
defaults".
3. Release the keys. The IP terminal is started with the initialization values.
4.5
Registering the IP Terminal with the System
The IP terminal registers on the system itself after a restart (see "Initialization and
Restart of an IP Terminal", page 23).
4.5.1
Registering Process
The IP terminal registers with the AIPcard whose IP address is configured under
"AIP Address" in the terminal, and notifies it of its own IP address.
The AIP software checks whether the same IP address has already been assigned
to a user-network interface with subscriber data in the AIMS configuration, and
responds as follows depending on the result:
• The IP address has already been assigned to a user-network interface:
– The IP terminal is assigned to the same user-network interface.
– The user-network interfaces including user name and call number are
available to the terminal.
– The registering process is completed.
• The IP address has not been assigned to any user-network interface:
– The IP terminal is assigned to the next available user-network interface with
preconfigured subscriber data (user-network interfaces without assigned
subscriber data are not active).
– The preconfigured subscriber settings including user name and call number
are available on the terminal, and the registering process is completed.
24
and the key "0", 5 seconds after start of
MENU
IP Terminal Office 35IP
Advertisement
Table of Contents
