Maintenance - DeLonghi DCH5915ER Instructions For Use Manual

ADDITIONAL SAFETY FEATURES
Overheating protection: a safety device switches
-
the heater off if it accidentally overheats (e.g.: air in-
take and outlet grilles obstructed, filter clogged). In
this case remove the plug from the power outlet and
leave it unplugged for a few minutes, eliminate the
cause of overheating, then plug the fan heater back
and turn it on again. If the appliance doesn't work
please contact the De'Longhi Customer Service.
Please note: To avoid overheating the appliance, do
not cover it.
Tip over safety switch: a safety tip-over switch turns
-
the heater off if it tips over or is positioned in an im-
proper way that could jeopardize safety.
The appliance emits a beep and the display will show
a blinking dot. After the appliance has been restored
in the vertical position it will take just few seconds to
start on again.
Alarms
The appliance has a diagnostic system that makes it possible
to signal malfunctions.
In case of problems, the display will show an alarm message:
(Probe failure) and
troubleshooting section.

MAINTENANCE

- Before carrying out any maintenance, always remove
the plug from the power outlet.
- During the season when the appliance is being used,
regularly clean the air intake and outlet grilles using a
vacuum cleaner.
- Never use abrasive powders or solvents to clean the ap-
pliance.
- Remove the back grille by pulling it outward.
- Remove the dust filter that filters impurities from the
air taken in from the room, blow it lightly, then reposi-
tion it in the appliance.
(High temperature), see
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pur-
suant to Part 15 of the FCC Rules. These limits are de-
signed to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the in-
structions, may cause harmful interference to radio com-
munications. However, there is no guarantee that inter-
ference will not occur in a particular installation. lf this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit dif-
ferent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV techni-
cian for help.
Modifications not approved by the party responsible for
compliance could void user's authority to operate the
equipment.
CAN ICES-3 (B) / NMB-3 (B)
7