DeLonghi DCH5915ER Instructions For Use Manual page 6

OPERATION AND USE
- Connect the appliance to the power outlet.
- The appliance emits a beep and the power indicator
light (H) comes on and remains on as long as the ap-
pliance is powered.
- The appliance goes into OFF. If the display show a
blinking dot, it means that the tip over switch has been
activated. See paragraph: "Additional safety features" .
- Press the ON/OFF button (A) to turn on the appliance. It
will begin to heat with the predefined settings.
MODE button
Press the MODE button (F) to select one of the following
functions available:
Ventilation
-
In this operating mode only the fan operates, so the
appliance does not heat the room.
Anti-freeze
-
In this operating mode the appliance keeps the room
at a temperature of 45°F (7°C) to prevent freezing tem-
peratures.
Heating 1 and Heating 2
-
In this operating mode you can set the desired tem-
perature by pressing the + and - adjustment buttons
(B).
Heating 1 (minimum power level):
l
The appliance operates at the minimum power reduc-
ing noise and energy consumption to the minimum.
Heating 2/BOOST function (maximum power
l
level):
The appliance operates at the maximum power for
rapid heating of the room.
Eco function
In this operating mode the appliance will automatically set
the power level to guarantee the best comfort reducing the
energy consumption. In this operating mode the unit may
switch the heating power level from maximum to minimum
and viceversa, several times in an hour. When using the ECO
function, the maximum temperature setting is 79°F (26°C).
To activate this function, press the ECO button (D):
- If you want the appliance to distribute the airflow over
a larger area, press the oscillation button (C)
appliance will then oscillate right and left. To stop the
oscillation in the desired position, just press oscillation
button (C) again.
- To turn off the appliance press button ON/OFF (A). The
display will show a count down for about 6 seconds.
Please note: The display can show the temperature
in both °F and °C. To change the temperature scale, press
and hold the + key for few seconds, then release. Please be
informed that as this is not a precision device, the showed
temperature not necessary corresponds to the real one.
24-HOUR DIGITAL TIMER
This function can be activated from any operating mode.
Delayed switch-on: with the appliance in the OFF posi-
tion, press the timer button (E)
the symbol
To set the timer, use the + and - adjustment buttons (B),
then wait a few seconds for the programming to be set. The
display shows the symbol
timer. When the programmed time has been reached, the
appliance turns on with the same settings it had during the
previous operation.
Delayed shut-off: With the appliance on, press the timer
button (E) . The display shows the symbol
time remaining before shut-off. To set the timer, use the +
and - adjustment buttons (B), then wait a few seconds for
the programming to be set.
The display returns to show the current settings and the
symbol to indicate you have set the timer. When the
programmed time as been reached the appliance shuts off
automatically. If you want to go back to operation without
the timer, press the timer button (E) twice. The timer symbol
disappears from the display.
USING THE REMOTE CONTROL
The remote control functions correspond to those on the
control panel. See the section "Operation and Use" on the
previous page for a description of the functions.
Inserting or replacing the batteries
- Remove the cover on the rear of the remote control;
- Insert two AAA (R03/1.5V) batteries (included but
packaged separately) making sure they are in the cor-
rect position (see the instructions inside the battery
compartment);
- Do not mix old and new batteries;
- Do not mix alkaline, standard (carbon-zinc), or re-
. The
chargeable (ni-cad, ni-mh, etc) batteries;
- Replace the cover;
- Old batteries must be removed and disposed of in ac-
cordance with current legislation as they are harmful to
the environment.
6
. The display shows
and the time remaining before switch-on.
to indicate you have set the
and the