Replacing The Battery; User-Replaceable Parts - Fluke 707Ex Calibration Information Manual

Replacing the Battery

XW Warning
To avoid false readings, which could lead to
electric shock or injury, replace the battery
as soon as M (low battery indicator)
appears on the display.
Do not remove or install the battery within
the Ex-hazardous area.
Use only a single 9 V alkaline battery,
properly installed, to power the
mA Calibrator. See Table 2.
To replace the battery (refer to Figure 1 and Table 2):
1. Remove the test probes from the input signal.
2. Press D to turn the mA Calibrator OFF.
3. Remove the test leads from the input terminals.
4. Remove the red holster.
5. Lift off the battery door on the back of the mA
Calibrator as shown.
6. Remove the battery.
7. Insert the replacement battery and re-install the
battery door. Make sure it is securely in place.
8. Return the mA Calibrator to its red holster.
Figure 1. Replacing the Battery

User-Replaceable Parts

User-replaceable parts and accessories are shown in
Figure 2 and Table 1.
7
Item
A
Non-skid foot
Battery, 9 volt,
B
Alkaline
C
Battery door
D
Red holster, with bail
E
Alligator clips
F
Test lead set
G
Users Manual on CD
Battery Description
aqv07f.eps
Alkaline, 9 volt
Alkaline Ultra, 9 volt
Professional Alkaline
Battery Procell, 9 volt
Alkaline Energizer, 9 volt
Alkaline Power Line
Industrial Battery, 9 volt
Alkaline, 9 volt
User-Replaceable Parts
1
6
4
5
Figure 2. User-Replaceable Parts
Table 1. User-Replaceable Parts
Part Description Fluke Part No.
885884
822270 or
see Table 2
665106
2040228
AC72
TL75
2053979
Table 2. Approved Batteries
Manufacturer
Duracell
Duracell
Duracell
Eveready
Panasonic
Daimon
mA Calibrator
2
3
aqv10f.eps
Qty.
1
1
1
1
1
1
1
Type
6LR61
6LR61
6LR61
6LR61
6LR61
6LR61
5