O
P E R AT I O N
Memorizing the Channels
Your TV can memorize and store all of the available channels for both "off-air" (antenna) and
cable channels. After the available channels are memorized, use the CH
tons to scan through the channels. This eliminates the need to change channels by entering
the channel digits. There are three steps for memorizing channels: selecting a broadcast
source, memorizing the channels (automatic) and adding and deleting channels (manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the type
of signal source that is connected to the TV (i.e., an antenna or a cable system).
1
Press the Menu button.
Press the CH
select "Channel", then
press the VOL + button.
2
Press the CH
select "ANT/CATV", then
Press the VOL + or VOL -
button to cycle through
these choices:
ANT (antenna), STD, HRC
or IRC (all cable TV).
Note: STD, HRC and IRC identify various types of cable TV systems. Contact your local
cable company to identify the type of cable system that exists in your particular area.
At this point the signal source has been selected. Proceed to "Storing Channels in Memory"
(next page).
3.8
C
T
: TV O
HAPTER
HREE
PERATION
Antenna
ANT/CATV
button to
Auto Program
Fav. Channel
Fine Tune
Add/Erase
Labeling
button to
Antenna
ANT/CATV
Auto Program
Fav. Channel
Fine Tune
Add/Erase
Labeling
Channel
: A
: ANT
: 00
: - - - -
Channel
: A
: ANT
: 00
: - - - -
and CH
but-